Filter
Top Products
Chapter 9
56
Controlling Other Components
Programming to Control a Second Satellite Receiver
If you have another DISH Network satellite receiver installed, you can use this remote in
AUX mode to control it along with your new receiver. When you program the remote to
control this other receiver, the remote will send out IR signals to the receiver. You can
program the remote to control any other DISH Network satellite receiver, except for
following:
• TV2 on DISH 322, DISH Player-DVR 522, 625, and 942
• DishPlayer 7100/7200
1 Turn on the other receiver and display the System Info screen (see the user’s guide for
information on how to display the screen).
Write the address shown:
2 Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
3 Press the 3 button.
4 Use the NUMBER PAD to enter the address you wrote in step 1.
5 Press POUND (#). AUX blinks three times.
6 Press RECORD to make sure the address and the remote matches the address on the
receiver.
7 Press AUX and then try operating the other receiver.