Filter
Top Products
12
Making connectionsDX-60D260A13
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1 Make sure that your TV’s power cord is unplugged,
and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the
TV IN ANT/CABLE IN jack on the side of your TV and
to the antenna or cable TV wall jack.
3 Plug your TV’s power cord into a power outlet, then
turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press or to highlight TV then press ENTER.
6 If you cannot tune to channels you know exist, scan
for channels. See “Automatically scanning for
channels” on page 24.
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV’s power cord is unplugged
and the DVD or Blu-ray player is turned off.
2 Connect an HDMI cable (not provided) to the HDMI
jack on the side of your TV and to the HDMI OUT
jack on the DVD or Blu-ray player.
3 Plug your TV’s power cord into a power outlet, then
turn on your TV.
4 Turn on the DVD or Blu-ray player, then set it to the
correct output mode. For more information, see the
documentation that came with the player.
5 Press INPUT to open the INPUT SOURCE list.
6 Press or to highlight HDMI1, HDMI2, or HDMI3,
then press ENTER.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
Side of TV
Coaxial cable
Antenna or
cable TV (no box)
Note
You can also press HDMI repeatedly to select the
DVD or Blu-ray player.
Side of TV
DVD or Blu-ray player
HDMI cable
12-1236_DX-60D260A13 MAN_V1_EN.book Page 12 Thursday, March 21, 2013 8:17 AM