Filter
Top Products
24
Changing channel settingsDX-60D260A13
• News—Enhances vocals for TV audio. This
setting is good for watching news
broadcasts.
• Music—Preserves the original sound. This
setting is good for listening to music.
• Theater—Enhances treble and bass for a
rich sound experience. This setting is good
for watching DVDs, Blu-ray discs, and HDTV.
• Custom—Lets you manually adjust sound
settings.
• Treble—Adjusts the high sounds.
• Bass—Adjusts the low sounds.
• Balance—Adjusts the balance between the left
and right audio channels.
• Digital Audio/SPDIF—Sends digital audio to an
external audio system. You can select PCM (to
output audio in 2-channel stereo), or RAW (to
pass through the original digital audio sound).
• Audio Language—(Digital channels only)
Selects an alternate audio language, if available.
• MTS/SAP—(Analog channels only) Selects the
audio mode. You can select:
• Mono—Select this option if there is noise
or static on weak stereo broadcasts.
• Stereo—Select this option for programs
broadcast in stereo.
• SAP—Select this option to listen to a
secondary audio program, if available.
• Reset Audio Settings—Reset all audio settings
to factory defaults.
4 Press MENU to return to the previous menu, or press
EXIT to close the menu.
Playing TV audio only
You can turn off the picture on your TV and listen to the
program audio only.
To play TV audio only:
1 Press MENU. The on-screen menu opens with the
Picture menu displayed.
2 Press or to highlight Channels, then press .
The Channels menu opens.
3 Press or to highlight Audio Only, then press
ENTER.
4 Press or to select On.
5 Press MENU to return to the previous menu, or press
EXIT to close the menu. The picture turns off in
approximately three to five seconds.
Changing channel settings
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel information
in the channel list. When you press CH or CH , your
TV goes to the next or previous channel in the channel
list.
If the TV signal source changes, for example you change
from an outdoor antenna to cable TV (no box), you need
to scan for channels.
To automatically scan for channels:
1 Press MENU. The on-screen menu opens with the
Picture menu displayed.
2 Press or to highlight Channels, then press or
ENTER. The Channels menu opens.
3 Press or to highlight Auto Channel Scan, then
press ENTER. The Choose Your TV Source screen
opens.
Note
You can also press MTS/SAP one or
more times to select the audio mode.
Notes
• Audio only works only when the input source is
TV and your TV is receiving a broadcast signal.
• To exit audio only mode, press any button
except the power button. When you exit audio
only mode, the Audio Only option is
automatically reset to Off.
12-1236_DX-60D260A13 MAN_V1_EN.book Page 24 Thursday, March 21, 2013 8:17 AM