Filter
Top Products
Setting Up an Installed Disk Enclosure
2-5
Installing a DAE2
CAUTION
!
The drives read their FC-AL physical address only at powerup or
when the drive is reset. To avoid losing data, you must set the
enclosure address when power is off; you cannot change the EA
while power is on.
1. Set the enclosure address to the desired value, as shown in
Figure 2-1.
Figure 2-1 Setting the Enclosure Address (EA)
2. Plug an ac line cord from the cabinet’s power distribution unit
into each power/cooling module, as shown in Figure 2-2.
Make certain you secure the power cord with the strain reliefs at each
connector. The strain reliefs prevent the power cord from pulling out of
the connections.
EMC2310
Enclosure
Address
Switch
+
_
0