Filter
Top Products
3-12
2-Gigabit Disk-Array Enclosure (DAE2) Hardware Reference
Servicing a DAE2
2. If the active light is on steadily, pull the latch, and slowly pull the
module about 1 in (3 cm) from its slot. Wait 30 seconds for the
disk to stop spinning. Then remove the module and place it on a
padded, static-free surface.
If the active light is off or mostly off you do not need to wait for
the disk to stop spinning. Pull the latch and slowly pull the
module from its slot, as shown in Figure 3-7. Place it on a padded,
static-free surface.
Figure 3-7 Removing a Disk Module (FC Disk Carrier Shown)
Continue to the next section to install the replacement disk module.
Installing a Disk or Filler Module
Always replace a disk drive with another of the same model; do not mix Fibre
Channel and ATA components in the same enclosure. Refer to Figure 1-7 on
page 1-8 for a visual comparison of FC and ATA disk carriers.
1. Make sure an ESD wristband is attached to your wrist and the
enclosure (see the precautions on Page 3-7).
2. Align the module with the guides in the slot.
3. Gently push the module completely into the slot, and then engage
the latch. See Figure 3-8.
EMC2174