Filter
Top Products
Installing the SuperCombiner 12
Locate the Splitter
It will be in your cable box and will likely look like one of the following.
And it will have wires hooked into most or all of its connectors, so it might be
behind a cluttered mess.
Find the Powered Cable
The cable that was powered in the previous step should be connected to one of the
outputs of the splitter. To determine which cable has been powered, unplug the
cables one at a time and connect the Cable Finder Tool. If the red light doesn’t
illuminate plug it back into the splitter. When you find the cable that illuminates the
red light, you have found the cable running to Xtender.
The Cable Finder is a small light attached to a coax
connector – it comes with the optional installation kit.
You simply disconnect the cables one at a time and plug them into the cable-finder
tool – when you find the one that illuminates the light, you found the correct cable.
Wrong Cable!! Correct Cable!!
Note If you check all the cables connected to your splitter and none illuminates the
Cable-Finder light, see the troubleshooting guide.