Filter
Top Products
Installing the SuperCombiner 9
Installation Overview
Easy as 1-2-3
Step 1 – Install SuperCombiner
The SuperCombiner is a device that is installed just before your main
home “root splitter” to distribute your new BOCS channels all over your
home. In this step you will:
Decide where to put your Xtender.
Plug a special Cable-Finder into the nearest CATV outlet.
Find and open your cable splitter box.
Find the coaxial wire that goes to the room where you put Xtender.
Install the SuperCombiner.
Step 2 – Install the Xtender Unit
Xtender is connected to the three devices you want to control (just like
hooking up a new DVD player).
Xtender is connected (using stick-on IR emitter cables) to each of those
same three devices so Xtender can control them.
Xtender is connected to power and the Coax wall jack.
Step 3 – Program the Remote Controls
By punching in a few codes, the remote controls are programmed so they
know how to control both local TVs as well as the devices plugged into
Xtender.
Setup should take no more than 20 minutes for a typical home
A Quick Start Guide is provided in the Xtender package with large pictures of the
entire installation.