Filter
Top Products
Programming the Remotes 30
Troubleshooting:
General Sometimes while I’m
watching an Xtender
channel, the channel
or program changes
It’s possible someone else in the house
has pressed the same Xtender channel
button and has taken control. Consider
splitting the programs – perhaps Blue for
kids and Green for adults.
The video quality of
Xtender channels is
not as good as my
Cable TV channels
If you had an installer come out and put
in your Xtender system, they should
have already adjusted everything, but
just in case, Xtender allows you to adjust
the quality of your Xtender channels just
by using the remote control:
Make sure the remote knows how to talk
to Xtender - press the Red Xtender
channel button on the remote and make
sure the red light on the front of Xtender
blinks.
Now - go to the furthest TV from where
your Cable comes into your home - (if
you don't know where that is then just go
to the TV where you think the Xtender
channels are the weakest) - with the
Xtender remote for that room/TV- hold
down "MENU" and "1" until the power
light on the remote comes on. Now (as
long as you don't ever pause for more
than 10 seconds and the remote comes
out of program mode) you can press the
up arrow to make the signal stronger and
the down arrow to make it weaker - there
are about 16 different choices - once you
find one that looks good press the
select/OK button to save that setting.
We recommend you set the signal as low
as you can and get a good picture - just
setting it to its highest level could
interfere with other TV stations you
receive.
Now - you should go around to all the
other TVs and make sure they all look
good as well - you can up the signal
again to try to get the best picture
everywhere.
Keep in mind you are adjusting the
signal level for the whole house every
time you make this adjustment and not
just for the TV you are observing so be
careful.
Video
Quality
The video quality of
the Xtender channels
The Local-TV output on Xtender puts out
either Cable TV stations or Xtender