EDR910_1610_ma_en_rev1 00 - 33 -
3.5 MOTION DETECTION
Define all motion detection settings for the individual cameras in the MOTION
DETECTION menu.
Use the JOG to select the cameras from the list on the left.
(1) MOTION: ENABLE: Motion detection is activated.
DISABLE: Motion detection is deactivated.
ATTENTION: Motion detection is automatically deactivated upon opening an on-screen
display!
(2) SENSITIVITY:
Define the trigger sensitivity in 10 steps (1 – lowest, 10 – highest). Check the setting by
carrying out a moving test within the zone setting.
(3) DURATION:
Alarm duration upon motion detection. Duration applies to recording, screen change,
buzzer and output contact and is adjustable from 1~99 seconds.
(4) ALARM OUTPUT: Output relay activation.
1 : Output relay 1 is switched in
case of motion detection.
NONE: Output relay is deactivated.
COPY function
Motion detection settings can be copied from one camera to another. The zone settings
cannot be copied.
Select the camera to be copied from the camera list on the left and press the COPY key.
The message “COPIED” appears at the top screen margin. Select the camera which shall
apply the settings from the camera list. Press the SEARCH key to assign the copied
settings to the camera. The message “PASTED” appears at the top screen margin.
MOTION SETUP MENU
CAMERA 1 MOTION ENABLE
CAMERA 2 SENSITIVITY 07
CAMERA 3
CAMERA 4 DURATION 05 SEC
CAMERA 5 ALARM OUTPUT 01
CAMERA 6 E-MAIL NO
CAMERA 7 NETWORK NO
CAMERA 8 BUZZER DISABLE
CAMERA 9
SUMMARY MAIN MON NO CHANGE
CALL MON NO CHANGE
Menu dis
p
la
y
for EDR-910, EDR1610 identical, but with 16 cameras.