Filter
Top Products
EDR910_1610_ma_en_rev1 00 - 36 -
3.6 VIDEO LOSS MENU
Define the reaction upon video signal loss for each camera in this menu:
(1) VLOSS: ENABLE: Video loss detection is activated.
DISABLE: Video loss detection is deactivated.
(2) DURATION:
Alarm duration. Duration applies to buzzer and output contact and is adjustable from
1~99 seconds.
(3) ALARM OUTPUT: Output relay activation.
1: Output relay 1 ~ 4 (selection) is switched in
case of alarm
NONE: Output relay is deactivated.
(4) ALARM EMAIL:
By selecting “ON”, an email is sent in case of alarm, containing the alarm message and
the DVR IP address as sender. Define the email recipiant’s details in the NETWORK
menu.
(5) BUZZER: Alarm buzzer activation
ENABLE: Alarm buzzer is activated.
DISABLE: Alarm buzzer is deactivated.
(6) ALARM NETWORK:
Network alarm function activation. Network alarm reception requires installation of the
optionally available PowerCon software. The network alarm transmits both the alarm
message and the DVR IP address as sender to up to 3 recipiants.
YES: Network alarm is activated.
NO: Network alarm is deactivated.
(10) SUMMARY:
The SUMMARY menu item gives a summary on the settings for control purpose. Use the
JOG to browse the individual settings.
ATTENTION: This menu does not allow any editing of settings.
VLOSS SETUP MENU
CAMERA 1 VLOSS ENABLE
CAMERA 2
CAMERA 3 DURATION 05 SEC
CAMERA 4 ALARM OUTPUT 01
CAMERA 5 ALARM EMAIL NO
CAMERA 6 BUZZER DISABLE
CAMERA 7 ALARM NETWORK NO
CAMERA 8
CAMERA 9
SUMMARY
Menu dis
p
la
y
for EDR-910, EDR1610 identical, but with 16 cameras.