Filter
Top Products
MKP 2000 Remote Control Panel • Quick Start Guide QS-1
Install and set up the MKP 2000 as follows:
Step 1
Turn all of the equipment off and disconnect it from the power source.
Step 2
Install the cables to and from the control panel in a wall, podium, or
desk. See Rear Panel and Side Panel Connections in chapter 2,
Installation, for guidelines.
Step 3
Prepare the wall, podium, desk, or other surface to mount the MKP.
See Preparing the site, installing the mud ring or wall box in chapter 2,
Installation.
Step 4
Install the control panel in a wall, podium, desk, or other surface.
See Mounting the MKP to the mud ring or wall box in chapter 2, Installation.
Step 5
Connect the input and output cables. See Rear Panel and Side Panel
Connections in chapter 2, Installation, for guidelines.
Step 6
Connect the power supply. See Power supply wiring in chapter 2,
Installation.
Step 7
Connect power cords and turn on the equipment in the following
order: output devices (such as projectors or monitors), the connected
matrix switcher, and input devices (such as DSSs or cable boxes).
Step 8
If necessary, set the control panel’s and matrix switcher’s IP
parameters. See Viewing and configuring the IP and and MKP set-up
parameters in chapter 3, Local Operation, or System Settings Page in
chapter 5, HTML Operation.
Step 9
If necessary, set the control panel’s RS-232 port for pass-through or
no-pass-through mode and whether the MKP is the primary device
(connected to the switcher) or secondary device (connected through
another device). See Viewing and configuring the IP and and MKP
set-up parameters in chapter 3, Local Operation, or System Settings Page
in chapter 5, HTML Operation.
Quick Start Guide — MKP 2000