Filter
Top Products
TAPE MANAGEMENT
Setting the Tape Management Function
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the “7.TAPE
MANAGEMENT” line, then press the ENTER button.
ø The (TAPE MANAGEMENT) menu appears.
<TAPE@MANAGEMENT>
*TAPE@MANAGEMENT@@@@N
*PROTECT@DAY@@@@@@@30
*REC@PASS@SET@@@@@@10
*GROUP@NO.SET@@@@@OFF
*OVERRIDE@@@@@@@@@@@N
3
Press the ENTER button.
4
Press the l (or j) button to select the desired
mode, then press the ENTER button.
N. . . . . . . The tape management function is not
active.
Y. . . . . . . The tape management function is
active.
When setting to “Y”, please continue with the
settings below.
5
Press the l (or j) button until the “PROTECT DAY”
setting is highlighted, then press the ENTER button.
6 Press the l (or j) button to select the desired
number of days to protect the tape, then press the
ENTER button.
OFF . . . . The tape is not protected.
1-255 . . . Number of days to protect the tape
(prevent over-recording), from the date
of the last recording on the tape (or the
last expected recording date (calculated
using the tape length (T-160) and the
recording speed)).
NOTE:
œ Since the last expected recording date is a
calculated date (using the tape length (T-160) and
the recording speed), it may be different from the
actual last recording date, due to other settings
such as alarm recordings.
7
Press the l (or j) button until the “REC. PASS
SET” setting is highlighted, then press the ENTER
button.
8
Press the l (or j) button to select the desired
number of re-recording times, then press the ENTER
button.
OFF . . . . The number of re-recording times will
not be checked.
1-100 . . . Maximum number of re-recording
times. (Refer to “Concerning the
Number of Times Tapes can be
Rerecorded on” on page 19.)
NOTES:
œ Since data is read before it is recorded, the
number of times will be incremented even if the
recording is stopped before the end.
œ During autorepeat recording, the re-recording
times count will be updated every time the tape is
rewound to the beginning. Autorepeat recording
will proceed even if the count exceeds the “REC
PASS SET” setting. If “WARNING” in the
(BUZZER SET) menu is set to “Y”, the buzzer is
heard.
9 Press the l (or j) button until the “GROUP NO.
SET” setting is highlighted, then press the ENTER
button.
F
Press the l (or j) button to select the desired group
number, then press the ENTER button.
OFF . . . . The group number will not be checked.
1-15 . . . . Group number setting.
G
Press the l (or j) button until the “OVERRIDE”
setting is highlighted, then press the ENTER button.
H
Press the l (or j) button to select the desired
override mode, then press the ENTER button. (Refer
to “Tape Management Conflict Display” on the next
page.)
N. . . . . . . Only EJECT button operation is
accepted after a conflict has occurred.
Y. . . . . . . The next operation is accepted after a
conflict has occurred. This will override
setting.
I
Press the MENU EXIT button.
NOTES:
œ Once the tape management data is recorded on
tape, it cannot be changed.
œ The criteria (condition) for allowing recording will be
based on the data recorded on the tape and not the
settings in the (TAPE MANAGEMENT) menu.
NF4Q/NA (SRC-850A GB) Tue. Sept., 10/2002
English
17