Filter
Top Products
TAPE MANAGEMENT
Tape Management Conflict Display
If a conflict that prevents recording is found when the
tape management function checks the tape data, the
(TAPE MANAGEMENT) menu appears with the
conflicting setting flashing and the VCR go into the stop
mode. If “WARNING” in the (BUZZER SET) menu is set
to “Y”, the buzzer is heard. (To stop the buzzer, press
the STOP button.)
NOTES:
œ If “OVERRIDE” is set to “N” (No), the conflicting
setting is displayed flashing and the message
(PRESS EJECT) appears at the bottom of the screen.
Recording under these conditions is not possible.
Press the EJECT button to eject the tape. To record
on the same tape, set the “OVERRIDE” setting to “Y”
and modify the conflicting setting, then insert the
same tape and press the REC button. However, if
only “PROTECT DAY” and “REC PAS SET” are
modified, the menu will be displayed again. Press the
REC button one more time to start recording.
Recording starts and the tape data is updated.
Conflict display sample
<TAPE@MANAGEMENT>
*TAPE@MANAGEMENT@@@@Y
*PROTECT@DAY@@@@@@@30
@LAST@M/D@@@@@@NEXT@M/D
@@@@@10/15@@@@@@@@@11/15
*REC@PASS@SET@@@@@@10
@PASS@COUNT@@@@@@@@10
*GROUP@NO.SET@@@@@@@7
@REC@GR.NO.@@@@@@@@@8
*OVERRIDE@@@@@@@@@@@N
@@@@@(PRESS@EJECT)
œ If the “OVERRIDE” is set to “Y” (Yes), the (TAPE
MANAGEMENT) menu is displayed and conflicting
setting preventing recording will flash and the VCR will
switch to stop mode.
To enter recording mode, press the REC button.
PROTECT DAY CONFLICT
The tape is protected, and the tape protection term
(ex. 30 days) is not yet over.
Under “LAST M/D”, the date of the last recording on
the tape (or the last expected recording date
(calculated using the tape length (T-160) and the
recording speed)) is displayed.
Under “NEXT M/D”, the date when it will be possible
to record on the tape again is displayed.
REC PASS SET CONFLICT
The set number of recording passes has been
reached.
The “PASS COUNT” shows the number of recording
passes on the tape (ex. since the maximum recording
passes number is set to “10”, this prevents further
recording.)
NOTES:
œ When conducting Autorepeat recording, if the
“PASS COUNT” exceeds 100, “101*” will be
displayed flashing.
œ If using a tape recorded previously on a different
type of VCR (no tape data), when the set number
of recordings is exceeded, “USED” will flash next to
the “PASS COUNT” number.
GROUP NO. SET CONFLICT
The group numbers do not match.
The “REC GR. NO.” shows the tape recording group
number (ex. this tape belongs to a different recording
group number 8 than the one set 7.)
NF4Q/NA (SRC-850A GB) Tue. Sept., 10/2002
18
English