Filter
Top Products
NORMAL RECORDING
Tape Counter Notes:
œ There is no tape counter indication for the blank
portions of the tape.
œ The tape counter indicates real hours, minutes and
seconds.
œ There may be a slight discrepancy between the
position shown on the tape counter and the actual
tape position.
œ When rewinding the tape past the “0:00:00” position, a
minus (–) sign will be displayed.
œ When the counter is displayed on the digital display
panel, press the COUNTER RESET button to reset it
to 0:00:00.
Action to Take when the Video Signal
Deteriorates
If there is no video signal during recording or when a
menu is not displayed (in stop, fast forward or rewind
modes, etc.), “VIDEO LOSS” can be displayed
on-screen. If in the (WARNING OUT/EJECT SET) menu,
“VIDEO LOSS” is set to “Y”, the output at the WARNING
OUT terminal becomes 0V (Low) (Refer to “WARNING
OUT Terminal” on page 36).
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the “4.GENERAL
SET” line, then press the ENTER button.
ø The (GENERAL SET) menu appears.
<GENERAL@SET>
TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
THREAD@CHECK@@@@@N
VIDEO@LOSS@@@@@@@N
REMOTE@@@@@@@@@@@MENU
VIDEO@@@@@@@@@@@@COLOR
3
Press the l (or j) button until the “VIDEO LOSS”
setting is highlighted, then press the ENTER button.
4
Press the l (or j) button to select the desired
mode, then press the ENTER button.
N. . . . . . . . . . The video loss warning is not
active.
Y. . . . . . . . . . The video loss warning is active.
5
Press the MENU EXIT button.
NF4Q/NA (SRC-850A GB) Tue. Sept., 10/2002
20
English