Filter
Top Products
OUTPUT TERMINALS
SW OUT Terminal
When recording, a pulse signal is output at the SW OUT
terminal.
This terminal is usually connected to the switch input
(SW IN) of devices like a camera switcher unit, or a quad
compressor.
SW OUT Terminal Output Setting
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the
“2.DISPLAY/SW OUT SET” line, then press the
ENTER button.
ø The (DISPLAY/SW OUT SET) menu appears.
<DISPLAY@SET>@@@@SET@UP
DATE@@@@@@@@@@@@@Y
TIME@@@@@@@@@@@@@Y
ALARM@COUNT@@@@@@Y
<SW@OUT@SET>
TIMING@@@@@@@@@@@FIELD
FIELD@@@@@@@@@@@@1
OUTPUT@@@@@@@@@@@Y
3
Press the l (or j) button until the “TIMING” setting
is highlighted, then press the ENTER button.
4
Press the l (or j) button to select the desired
output timing, then press the ENTER button.
FIELD. . . . . . 1 pulse is output after each set
number of fields.
FRAME . . . . 1 pulse is output after each set
number of frames.
5
Press the ENTER button.
6
Press the l (or j) button to select the desired pulse
signal interval (1, 2, 3, 4, 5, 10, 30 or 60), then press
the ENTER button.
œ If “TIMING” is set to FRAME (see step 4),
“FRAME” will be indicated instead of “FIELD”.
7
Press the ENTER button.
8
Press the l (or j) button to select the desired
“OUTPUT” mode, then press the ENTER button.
Y. . . . . . . . . . When recording, a pulse signal is
output.
N . . . . . . . . . When recording, a pulse signal is
not output.
9
Press the MENU EXIT button.
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
FIELD: 16.7 msec.
FRAME: 5 msec.
NF4Q/NA (SRC-850A GB) Tue. Sept., 10/2002
English
35