Filter
Top Products
SETTING THE CASSETTE EJECT MODE
Cassette Eject Setup
When using 2 VCRs or more, the cassette tape of all the
VCRs or some of the VCRs can be ejected, if the EJECT
terminals on the VCRs are connected as indicated.
1 Press the MENU button until the (SET UP 4) menu is
displayed.
@@@@@@@<SET@UP@4>
öSW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@8H@@@@@@@@@@@@Y
öTHREAD@CHECK@@@Y
öVIDEO@LOSS@@@@@N
öREC@SPEED@@@@@@N
öEJECT@SET
@@EJECT@MODE@@@@EJECT1
@@OPERATION@@@@@SLAVE
2 Turn the JOG dial, until the “EJECT MODE” setting is
flashing.
3 Turn the SHUTTLE ring to set the desired cassette
eject mode.
EJECT1 . . . . The cassette is ejected only if the
VCR is not in recording mode.
EJECT2 . . . . The cassette is ejected only if the
VCR is in stop mode.
4 Turn the JOG dial clockwise, until the “OPERATION”
setting is flashing.
5 Turn the SHUTTLE ring to set the desired operation.
SLAVE . . . . . When the EJECT button is pressed,
the cassette tape of that VCR only will
be ejected.
MASTER . . . When the EJECT button is
pressed, the cassette tape of that
VCR and of any VCR connected
after it will be ejected.
6 Press the SEARCH button to save the settings.
ø
The setting procedure is now completed.
NOTE:
œ The EJECT button will not be operative during
recording mode.
EJECT terminal connection
EJECT IN terminal
œ Depending on the (SET UP 4) menu “EJECT
MODE” setting (see “Cassette Eject Setup”), the
cassette loaded in the VCR is ejected when there
is an input at this terminal.
EJECT OUT terminal
œ When the EJECT button is pressed (if the VCR is
setup as “MASTER”, see step 5 under “Cassette
Eject Setup”) or when there is an input (trigger) at
the EJECT IN terminal, a signal is output at this
terminal, even if the security lock is set or if a
cassette is not loaded.
VCR No. 1
EJECT
OUT IN
VCR No. 2
EJECT
OUT IN
COM
COM
RC4QR/U (SRT-7168 GB) Mon. Sept., 11/2000
32 English