Filter
Top Products
OUTPUT TERMINALS
REMOTE Jack
You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
NOTE:
œ The functions not available on the VCR will not operate.
Remote control of the VCR is possible by connecting a
remote controller with a circuit such as indicated below, to
the REMOTE jack.
NOTES:
œ Use a 3.5 mm mini-jack type plug.
œ The connection should be done using a shielded cable
no more than 5 meters long.
œ The functions not available on the VCR will not operate.
Remote control setting
The remote control switch 7 can be set to either eject the
tape or access the menus.
1 Press the MENU button until the (SET UP 1) menu is
displayed.
@@@@@@@<SET@UP@1>
öDAYLIGHT@SET@@@@@USE
@@@@@@@@WEEK@MONTH@TIME
@ON@@@1ST-SUN@@04@02:00
@OFF@@LST-SUN@@10@02:00
öOUTPUT@@@@@@@@SERIES
öCLOCK@SET
@10-15-99@FRI@@15:20:00
öREMOTE@@@@@@@@EJECT
öLANGUAGE-LANGUE-IDIOMA
@@@ENGLISH
2 Turn the JOG dial, until the “REMOTE” setting is
flashing.
3 Turn the SHUTTLE ring, to select the desired switch
mode.
EJECT . . . . . Switch 7 will eject the tape.
MENU . . . . . Switch 7 will display the menu.
4 Press the SEARCH button to save the setting.
SW0: EJECT
R0 1.2K
Remote control circuit
The resistance tolerance is
2% or less.
SW2: STILL/PAUSE
SW3: REW
SW4: FF
SW5: PLAY
SW6: REC
SW7: EJECT (or MENU)
SW8: REV
SW1: STOP
SW9: REC/PLAY SPEED j, j
SW10: REC/PLAY SPEED l, l
SW11: SHIFT ], »
SW12: SHIFT «, «
R2 0.43K
R3 0.51K
R4 0.62K
R5 0.75K
R6 0.91K
R7 1.1K
R8 1.3K
R1 0.3K
R9 2.0K
R10 2.4K
R11 3.6K
R12 5.6K
RC4QR/U (SRT-7168 GB) Mon. Sept., 11/2000
English 37