Filter
Top Products
Operating Voltage:
Remote Turn-On Voltage:
Internal Fusing in SXRC
Interface Box:
Maximum Amplifiers:
Maximum Groups:
DRVC Range:
Power, Ground, Remote
Terminals:
Mounting Hardware:
9-16 volts DC
9-16 volts DC
Mini Glass Fast Blow 3 amp
16 units
10 groups
30 dB
Removable plug will accept
up to 12 gauge wire.
Standard DIN 7-3/16 x 2-1/8
182mm x 53mm
79
SXRC Remote Control
Specifications
A few words on the Kompressor™. The effect is most
noticeable in the bass area of your music (Bass/Midbass). You
can use the Kompressor™ in any amplifier configuration
(Low Pass, High Pass, Band Pass or Full Range) but we feel the
most dramatic results are obtained when the amp is in a Low
Pass (subwoofer) or Band Pass (midbass) situation.
A few exceptions to this statement are:
The
red-line setting is good for use in any configuration
as it helps control dynamic peaks and limit distortion at
higher output levels. VERY effective at controlling speaker
damaging distortion caused by over-driving or clipping the
amplifier.
The
contour setting is also another good all around use
setting and when used in Full Range or High Pass
configurations tends to enhance the vocal and top end of
the music. Great for helping to cover up interior noise.
The
ATTACK setting is really geared for bass and midbass
duty but can be used in any setup.
Remember, these are just suggestions, play around with each
Kompressor™ preset and the Threshold (KOMP ADJ) to find
what works for you.
The possibilities are almost endless! Tweak away!
SXRC Specifications
HOME
HOME
ENT
ENT
ESC
ESC
M1
M1
M2
M2
M3
M3
M4
M4
SYSSYS
MEM-1MEM-1
GAINGAIN EQEQ LPFLPF HPFHPF KOMPKOMP
AMP1AMP1
LOCKLOCK
MEM-2MEM-2 MEM-3MEM-3 MEM-4MEM-4
PHASEPHASE
MUTEMUTE
AMP2AMP2
LEFTLEFT RIGHTRIGHT
** ** kkiicckkeerr