Filter
Top Products
Using your TV
11
Connecting an analog audio device
To connect an analog audio device:
• Connect one end of an audio cable to the AUDIO IN L and R jacks
on the audio device, then connect the other end of the cable to
the AUDIO OUT jacks on the back of your TV.
Connecting a computer
Note: Make sure that the VGA cable has a ferrite core.
To connect a computer:
1 Connect one end of a VGA cable to the VGA jack on the computer,
then connect the other end of the cable to the PC-IN jack on the
back of your TV.
2 Connect one end of a mini-plug audio cable to the
AUDIO LINE OUT jack on the computer, then connect the other
end of the cable to the PC-IN AUDIO jack on the back of your TV.
Using your TV
Turning your TV on or off
To turn your TV on or off:
•Press POWER.
Warning: When you press POWER to turn off your TV, your TV goes into
Standby mode. It is still receiving electrical power. To completely
disconnect power, unplug the power cord.
Note: When your TV does not receive a signal and you do not press any
buttons for 15 minutes, your TV goes into Standby mode.
Setting up for the first time
The first time you turn on your TV, a quick setup program starts that lets
you select a language for the on-screen menu, select the TV signal
source, and scan for available channels.
To set up your TV for the first time:
1 Make sure that your TV is connected to an antenna, cable TV, or
satellite TV.
2 Press POWER. You may have to wait a few seconds for your TV to
initialize. After your TV turns on, the Initial Setup screen opens.
3 Press or to select English, Español, or Français, then
press ENTER. The following screen opens.
4 Press or to select Air (antenna) or Cable (cable or satellite
TV), then press ENTER. The following screen opens, and your TV
starts scanning for channels. Your TV stores the channel
information in the channel list.
When the scan is complete, the lowest channel in the channel list
is displayed.
Notes:
The initial setup program only runs once for Air or Cable. If you change the
TV signal source, you need to re-scan for channels. For more
information, see “Scanning for channels” on page 12.
If you press POWER or MENU while your TV is scanning for channels,
scanning will stop.
AUDIO IN
RL
Analog audio device
AUDIO OUT jacks
Computer
Mini audio cable
VGA cable
Ferrite core
PC-IN video jack
PC-IN AUDIO jack
Initial Setup
Initial Setup
Select the language for setup display.
Elija el idioma de ajuste.
Sélectionner langue écran config.
Select Enter Exit
MENU
Español
Français
ENTER
English
Initial Setup
Initial Setup
Air
Cable
tixEretnEtceleS
MENU
Back
BACK
ENTER
Make sure the antenna is connected to "ANT.IN" jack.
Select the destination of "ANT.IN" jack.
Air
Cable
Or
ANT.IN
Initial Setup
Initial Setup
Now the system is scanning for channels,please wait.
Exit
MENU
5%
Analog channels 1ch
Digital channels 0ch
08-1262_DXLCD37-09.fm Page 11 Wednesday, April 16, 2008 12:56 PM