Filter
Top Products
25
Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting Tips Consumer Support
GEAppliances.com
How to Set the Oven for Cleaning
Touch SELF CLEAN.
For double oven models only, touch
UPPER OVEN or LOWER OVEN to
select the desired oven.
Three self clean time options are
available:
■ LIGHT CLEAN – Touch for an
automatic 3-hour clean time.
Recommended for use when
cleaning small, contained spills.
■ REGULAR CLEAN – Touch for an
automatic 5-hour clean time.
Recommended for a dirtier oven.
■ CUSTOM – Touch and, using the
numbers, set a clean time
between 3 hours and 7 hours and
30 minutes, depending on how
dirty your oven is.
Touch NOW.
The door locks automatically. The screen
will show the clean time remaining. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and OVEN LOCKED
goes off.
When OVEN LOCKED goes off, you will be
able to open the door.
■ The words LOCK DOOR will appear and
the oven control will signal if you set
the clean cycle and forget to close the
oven door.
■ To stop a clean cycle, touch the
CANCEL or CLEAR/OFF pad. When OVEN
LOCKED goes off, indicating the oven
has cooled below the locking
temperature, you will be able to open
the door.
On double oven models, you can set a clean in
both ovens at the same time. The second oven set
will automatically delay the start of cleaning until
the end of the first oven’s clean cycle.
To set the second oven, there are two
options available:
■ Immediately after setting the first oven:
Select PRESS TO MAKE LOWER OVEN
SELECTIONS or PRESS TO MAKE UPPER
OVEN SELECTIONS as needed and
follow steps 3 and 4.
■ From the home screen:
Touch SELF CLEAN.
Touch LIGHT CLEAN, REGULAR CLEAN
or CUSTOM. See above for
reference.
Touch START AFTER 1ST SELF CLEAN
for the second oven to automatically
start cleaning after the first oven has
finished.
OR
UPPER
OVEN
LOWER
OVEN
SELF CLEAN
LIGHT
CLEAN
OR
REGULAR
CLEAN
CUSTOM
OR
09876
54321
On double oven models only.
NOW
(Numbers will only be used when
setting a CUSTOM clean time.)