Filter
Top Products
35
Appendix A - Advanced Connections
1 CONNECT CABLE TO
CABLE BOX
Connect an RF antenna cable from
your cable wall outlet to the “In
from Cable” jack on the Cable Box.
2 CONNECT CABLE BOX TO
DVD+VCR
Connect a second RF cable from
the “Out to TV” jack on the Cable
Box to the “IN (FROM ANT.)” jack
on the back panel of the DVD+VCR.
3 CONNECT DVD+VCR TO TV
Connect the supplied RF cable from
the “OUT (TO TV)” jack on the back
panel of the DVD+VCR to your
television’s “Antenna In” jack.
4 PLUG IN DVD+VCR
Connect the DVD+VCR power cord
to a standard 120V/60Hz wall
outlet.
5 TURN ON TV, DVD+VCR &
CABLE BOX
Press POWER on the remote
control, TV, and Cable Box.
Follow these instructions to connect a Cable
Box to your DVD+VCR.
Input
Output
Cable Box
VHF/UHF
TV
From Cable
Wall Outlet
CABLE BOX HOOKUP
6 SET DVD+VCR OUTPUT
CHANNEL
Set the CH (channel) switch on the
back panel of the DVD+VCR to 3 or
4, whichever is NOT used by your
cable box.
7 TUNE TV TO THE SAME
CHANNEL
Select the channel you used in step
6.
8 CONNECTION IS COMPLETE!
The “Language/Langue/Idioma”
menu will appear on your television
screen. Please proceed with Auto
Setup on page 3.
• Use your cable box to select
channels.
• If you are not getting a good
picture, repeat steps 6 and 7
using the other channel; i.e.
channel 4 instead of channel 3.