Filter
Top Products
8
Installation
3.1.2 Using the Optional Sun Shield
The optional sun shield was designed to increase the readability of the display
by
screening it from direct sunlight. See Replacement Parts on page 21 for
ordering information.
Figure 3-6 Sun Shield Kit Components
Figure 3-7 Mounting the Controller in the Sun Shield
1. Sun shield 5. Pipe mounting brackets (2), includes items 6 and 7, Cat. No. 9H1079
2. Pan head screws, M6 x 1.0 x 12 mm (6),
Cat. No. 200-1025
6. Hex/slotted head screw,
5
/16-inch x 1.0-inch
(supplied with item number 5)
3. Lock washers, ¼-inch I.D. (2), Cat. No. 8H1336 7. Square nut,
5
/16-inch (supplied with item number 5)
4. Hex nuts, M6 x 1.0 (2), Cat. No. 5867300 8. Uni-strut, 27 cm (10.5 inch) length, Cat. No. 276F1227
1. Sun shield 4. Hole pattern for mounting controller 7. Pipe mounting bracket–slide into
uni-strut as shown. Secure the
fasteners to complete installation.
2. Uni-strut (rotate 90° as required) 5. Pipe (vertical or horizontal as required)
3. Pan head screw, lock washer (2 each) 6. Hex/slotted head screw and square nut
1
2
3
4
5
8
6
7
1
3
4
2
7
6
5
2