Filter
Top Products
RECORDING
43
time available.
• If "CAPTION1", "CAPTION2", "TEXT1" or "TEXT2" is selected, the On Screen Display will
appear for 5 seconds, then disappear.
If you want to check the remaining pause time available using the On Screen Display,
press SELECT button. The On Screen Display will appear for 5 seconds.
OTR (One Touch Recording)
This function enables you to set a recording length simply by pressing the REC/OTR
button on the TV/VCR.
Make sure...
• Power must be turned on.
• Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or
fast forward the tape to the point at which you want to begin recording.)
NOTE: This function cannot be done by the remote control.
1 Select the channel to be recorded
Press number buttons on the remote control or the CH or button.
2 Begin OTR
Press REC/OTR button on the TV/VCR as many times as needed. The recording
length will be determined by the number of times you press REC/OTR button.
Each additional push will increase the recording time by 30 minutes. It is set up to 8
hours.
HINTS:
• Recording starts immediately when the REC/OTR button is pressed.
• When REC/OTR button is pressed 18 times, the TV/VCR will switch to the Normal
Recording mode.
• To stop the OTR operation, press STOP button on the TV/VCR or on the remote
control.
• To show the remaining time, press SELECT button repeatedly until "OTR" appears
on the TV screen.
• Recording stops when 0:00:00 is reached.
• Please note that in the SLP mode maximum recording time, assuming the tape is
started at the beginning, is 8 hours using T-160 (or 6 hours using T-120).
• If the tape runs out before the end time, the TV/VCR will switch to the Stop mode
immediately, eject the tape and the TV/VCR power will be turned off.