Hitachi 65S700 Projection Television User Manual


 
NOTE: Any power interruption during the upgrade process will cancel the upgrade. When this happens, repeat the upgrade
procedure.
SETUP
72
Upgrades
THUMB
STICK
SELECT
Move
SEL
Select
Software Version: Main V00.15
1394 V00.07
MMC Software Upgrade
Please insert MMC card
before upgrading.
Upgrade Now
Setup
Upgrades
Upgrades
Set Timer Recording
Setup
Set Stand-By Mode
Move
SEL
Return
Set Monitor Out
This function only works in ANT C (Digital Signal). It shows software information and easy upgrade
procedure. This function allows the TV software to be upgraded by using a flash card (MMC Card). If a future
software upgrade is required for your TV, Hitachi will notify and provide you with a flash card. In order to
receive written notification and the flash card, please complete and return the warranty card.
Insert MMC card, then press THUMB STICK ̆, ̄ to highlight “Upgrade Now”. Press down on THUMBSTICK to select and start
upgrading.
Set Stand-By Mode
THUMB
STICK
SELECT
Move
SEL
Return
If you want to use the IEEE1394
function in the Stand-By, please
set the IEEE1394 Stand-By mode.
IEEE1394 Stand-By
Setup
Set Stand-By Mode
Upgrades
Set Timer Recording
Setup
Set Stand-By Mode
Move
SEL
Return
Set Monitor Out
This function sets the IEEE1394 in Stand-By Mode.
This feature will select the source of the Monitor Output.
Set Monitor Out
THUMB
STICK
SELECT
Move
SEL
Return
Monitor Out
Monitor
TV Tuner Out
Setup
Set Monitor Out
Upgrades
Set Timer Recording
Setup
Set Stand-By Mode
Move
SEL
Return
Set Monitor Out
Monitor- Select Monitor to output the audio and video signals of the chosen input source (ANT A, ANT B, VID3-VID5) to a VCR or other
A/V device. It will also send digital audio and video signals from ANT C - DTV and IEEE1394 devices that are not copy
protected.
TV Tuner Out- Select TV Tuner Out to output the audio and video signals of the last watched Antenna Source (ANT A, AN T B, ANT C).
Use THUMB STICK ̆, ̄ to highlight the function to change then press down on THUMB STICK to select the function.
Press EXIT to quit menu or THUMB STICK ̇ to return to previous menu.
ON-SCREEN DISPLAY