Hitachi DV PF74U DVD VCR Combo User Manual


 
16
EN
1L25
6 After scanning, the tuner stops on the low-
est memorized channel.The TV screen
returns to TV mode.
¡If “AUTO SET UP” appears on the TV screen again,
check the cable connections. Press B once again and
the DVD/VCR will begin preset again.
AUTOMATIC CHANNEL SET UP
SETUP
You can automatically program the tuner to scan only
the channels you receive in your area.
¡Channel memory programming is NOT needed when
you connect the DVD/VCR to a cable box or a satel-
lite box as in "DVD/VCR TO TV CONNECTION"
on page 14. In this case, select channel 3 on your TV.
Then, the channel you want to record or view may be
selected at the cable box or satellite box.
¡If noise appears, change the RF output channel of
the DVD/VCR to channel 4 by pressing PLAY for
3 seconds during playback. Then select the same
channel (CH4) on your TV.
¡Follow the steps below once. Repeat only if there is
a power failure or if the DVD/VCR is unplugged for
more than 30 seconds. (In these cases, the pro-
grammed channels are erased.)
¡You must follow the steps below before attempting
to play or record a video tape. If you want to play
or record a video tape BEFORE programming the
tuner, you can cancel it by pressing
CLEAR/C.RESET.
1 You need to connect the antenna or cable to
the DVD/VCR first.Then, connect the
DVD/VCR power plug to a standard AC outlet.
2 Turn on the TV and set the TV to channel 3.
¡If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback. Then select the same chan-
nel (CH4) on your TV. (See “RF Output Channel”
on page 14 for more details.)
3 Turn on the DVD/VCR by pressing y/I.
4 Select the On Screen Language (“ENG-
LISH”,“FRANCAIS” or
“ESPAÑOL”) by pressing
K
or L.Then, press B.
5 Begin channel preset by pressing B once.
The tuner scans and memo-
rizes all active channels in
your area.
¡The DVD/VCR distinguishes
between standard TV channels
and cable channels.
VCR
TO SELECT A DESIRED CHANNEL
You can select the desired channel by using CH (o/p)
or by directly entering channel numbers using the
Number buttons.
Note for using the Number buttons:
¡When selecting cable channels which are higher
than 99, enter channel numbers as a three-digit num-
ber.(For example: 117, press 1,1,7)
¡You must precede single-digit channel numbers with
a zero (For example: 02, 03, 04 and so on).
TO PRESET THE CHANNELS AGAIN
1 Press MENU until the main menu appears.
2 Select “CHANNEL SET UP” by pressing K
or L.Then, press B.
3 Select “AUTO SET UP” by pressing K or L.
Then, press
B.
¡After scanning, the tuner stops on the lowest memo-
rized channel.
LANGUAGE SELECT
ENGLISH [ON]
FRANCAIS
ESPAÑOL
AUTO SET UP
CH 01
H9651UD.qx3 04.3.2 8:54 PM Page 16