Filter
Top Products
Getting Started (Hookups cont.)
13
Getting Started (Hookups cont.)
We will guide you through this process. But first, turn the TV and the VCR around so you are
looking at their backs. Note the various input and output receptacles, their shapes, and how
they are labeled. Then read through the rest of this hookup section before proceeding to an
actual hookup.
DO NOT TURN ON THE POWER YET. FOR YOUR SAFETY, LEAVE YOUR TV AND VCR
UNPLUGGED WHILE HOOKING THEM UP.
3 Hook Up the Audio/Video Signal
If your TV is a fairly recent model, you probably have both audio and video jacks. Look on the
back of your TV for three jacks - possibly color-coded yellow, white, and red. They will be
labeled something like IN (L and R), AUDIO IN, or VIDEO IN. (If you are not sure, look at the
back of your VCR - you will see two sets of these jacks.)
If you have no jacks like these on your TV, skip this step and proceed to Step 4.
TV with Audio and Video Jacks
If you do find all three jacks on your TV, you need to purchase a three-line audio/video cable
with bell (RCA) connectors, like this:
If you find a video jack and only one audio jack, your TV is probably monaural. You can
purchase a two-line audio/video cable, but the three-line is handy in case you get a stereo TV
later.
Connect the yellow VIDEO OUT jack on the VCR to the VIDEO IN jack on the TV.
This direct video input will give you the best picture. It will also let you play videos in a "picture
in picture" feature, if your TV has it.
Then connect the AUDIO OUT jacks (red and white) on the VCR to the AUDIO IN jacks on
the TV (left to left, right to right).
This audio hookup will give you better sound than the RF signal hookup, because the
electronic signal won't have to go through a conversion process. Plus your VCR has a stereo
decoder, which your TV might not. For big speaker sound, you can also use these jacks to
connect the VCR to your stereo system (page 79).
Capabilities: The audio and video signal connections are all you need to play back a
prerecorded tape. If you do not intend to record on your VCR from your antenna/cable, then
you're all hooked up now. Otherwise, continue with Step 4, which will let you record off TV
channels.
4 Hook Up the RF Signal