Filter
Top Products
Getting Started (Hookups cont.)
16
Now continue with the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the IN
FROM ANT jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO TV jack
on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the TV
(where you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions provided
by this equipment.
5 Attach the TV and VCR to the Power Supply
Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord or
surge protector. See Important Safeguards for further precautions (page 3).
6 Install Batteries in the Remote Control
The remote control requires two fresh "AA" batteries. On the back of the remote, a plastic
cover slides off in the direction shown by the arrow. Remove this cover and install the
batteries, matching the plus end of each battery with the plus mark on the remote.
7 Switch the RF or Video Channel