Filter
Top Products
Reviewing Video Clips
Document 900.0856 Rev B 127
02/08
C
Reviewing Video Clips
You do not need to install any special software on your personal computer to review the
video clips. The copied video clip contains the Clip Player program.
1. If you used a USB device, disconnect either the external USB-IDE hard disk drive
or USB flash drive from the DVR, and connect it to your PC. If you used a
recordable CD, insert the CD in your computer’s CD drive.
2. Double-clicking the target clip file starts the Clip Player program.
Note It is suggested that the computer used for the Clip Player
program has at least an 800MHz Pentium III. If your CPU is
slower than this, video clips recorded at maximum speed with
very high image quality will be played back slowly. Also DirectX
8.0 or higher is required to run Clip Player, and a VGA card with
16MB or more video RAM is recommended for proper operation.
Figure C-1 Clip Player Screen