Filter
Top Products
Configuration
54
Figure 3-26 Port Numbers Setup Screen
d. Change the numbers by highlighting them and using the Up and Down arrow
buttons to increase or decrease the number.
The factory default Port settings are:
Remote Admin: 8200
Remote Callback: 8201
Remote Watch: 8016
Remote Search: 10019
Note The system restarts automatically after changing the port
settings.
Note Do NOT use the same port number for two different programs,
otherwise, the DVR cannot be connected with the PC running
RAS or WebGuard.
Caution When changing the port settings, you must change the port
settings on the PC running RAS or WebGuard as well. Refer to the
RAS Plus User Manual for details.
4. Selecting DHCP from the Type and highlighting Save reads the current IP
address of the DVR configured by DHCP (Dynamic Host Configuration Protocol)
network.