Filter
Top Products
**
This chapter describes how to search for channels and other series of procedures.
10.1 Automatic Search
If your product is connected to the aerial and television, you can automatically search channels without entering any
other information.
1. Select MENU button.
2. Select Installation using the
button and press the OK
or button.
3. Enter Password using the NUMERICAL (0-9) button.
4. Select Automatic Search from Installation menu using the
button and press the OK or button.
5. Automatic channel search begins.
Note: The Default Password is 0000.
**
Search
Wait while channel search continues. This may take a few minutes.
1. During operating search, the cursor is located at Stop . Therefore, if you press the OK
button during
searching, the operation is stopped and the channels found until then will be displayed.
2. If search operation is successfully completed and the channel does not exist, press the OK
button and try to
reset the search operation again if necessary.
3. You can delete unnecessary channels from the searched channels. Select your desired channels to delete and
press the OK
button. Then select Delete and press the OK button. To delete all channels, select Select
All to select all channels, select Delete, and press the OK
button.
4. When completing Channel Search and deleting unnecessary channels, select Save to save the changes.
10. Installation
GB 61