Filter
Top Products
14
Front & Rear Panels
—Continued
A
AUDIO OUTPUT [20–21]
These jacks output analog audio. The FRONT/
D.MIX jacks can be connected to the stereo input on
a TV, hi-fi amp, or other component. The 1 and 2
jacks output the same signals so you can use either.
DVDs with 5.1-channel audio are downmixed into
two channels before being output by the FRONT/
D.MIX jacks.
If you’re using an AV receiver or surround decoder
with a 5.1-channel analog audio input, use the
FRONT/D.MIX 1 or 2 jacks and the SURR L/R,
CENTER, and SUBWOOFER jacks. In this case,
you must set the Audio Output Mode on the Initial
Setup menu to 5.1 Channel. With this setting, the
FRONT/D.MIX jacks will output the front signals,
and the SURR L/R, CENTER, and SUBWOOFER
jacks will output the surround, center, and sub-
woofer signals respectively.
B
COAXIAL DIGITAL AUDIO OUTPUT [20]
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
C
OPTICAL DIGITAL AUDIO OUTPUT [20]
This optical digital audio output can be connected to
an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
D
COMPONENT 2 VIDEO OUTPUT [19]
These BNC connectors can be used to connect a TV
or projector with BNC component video inputs.
E
COMPONENT 1 VIDEO OUTPUT [19]
These RCA connectors can be used to connect a TV,
projector or AV receiver with component video
inputs.
F
VIDEO OUTPUT [18]
These RCA connectors can be used to connect TVs,
projectors or AV receivers with composite video
inputs.
G
S VIDEO OUTPUT [18]
These connectors can be used to connect TVs or
projectors with S Video inputs.
H
jacks [21]
These (Remote Interactive) connectors can be
connected to the connectors on your other Inte-
gra AV components for interactive control.
For remote control operation, you must make an
analog RCA connection between your DPS-6.5 and
the other AV component, even if they are connected
digitally.
I
IR IN/OUT [22]
The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
to pickup signals from the remote controller when
the DPS-6.5 is located in another room, installed in
a rack, or is out of range of the remote controller
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other AV components.
J
RS 232
This RS-232 port can be connected to an external
controller.
K
AC INLET [23]
The supplied power cord is connected here. The
other of the power cord should be connected to a
suitable wall outlet.
Rear Panel
R
L
SURR CENTER
12
FRONT/D. MIX
AUDIO OUTPUT
DIGITAL
SUB
WOOFER
OPTICAL
COAXIAL
VIDEO
OUTPUT
RS232
VIDEO
S VIDEO
PBY
P
R
PBY
P
R
COMPONENT 2 COMPONENT 1
REMOTE
CONTROL
IR
AC INLET
OUT
IN
MODEL NO.
DPS
-
6.5
RATING
:
AC 120
V 60Hz 11
W
SUPER AUDIO CD & DVD AUDIO/
VIDEO PLAYER
8 9 J6 74 5 K
321
DPS-6.5.book Page 14 Thursday, August 5, 2004 3:27 PM