Filter
Top Products
Intel® Server Chassis SC5400 User’s Guide 47
7. Firmly grab the PCI add-in board by its top edge or outer corners and remove from
the expansion slot on the server board. Place the removed PCI add-in board in an
anti-static protective wrapper. Close the back panel PCI add-in card retention
device.
8. Remove additional PCI add-in boards as necessary. When done, reinstall the PCI
add-in card retainer and close the PCI add-in card retention device(s).
9. Install the front bezel. For instructions, see “Removing and Installing the Front
Bezel” on page 18.
10. Install the chassis cover. For instructions, see “Installing the Chassis Cover” on
page 17.
11. Plug all peripheral devices and the AC power cable into the server.
12. Power up the server.
Installing PCI Add-in Board(s)
Caution: You may want to install an operating system before installing any add-in boards.
Do not overload the server board by installing add-in boards that draw excessive current.
Add-in boards can be extremely sensitive to ESD and always require careful handling.
After removing the board from its protective wrapper, place it component side up on a
grounded, static-free surface. Do not slide the board over any surface.
When removing a full-length add-in card, you must pull back on the latch on the plastic
card guide at the front of the chassis to release the card from the card guide.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover” on
page 16.
4. Remove the front bezel if it is installed. For instructions, see “Removing and
Installing the Front Bezel” on page 18.