Filter
Top Products
Intel® Server Chassis SC5400 User’s Guide 59
14. Re-install the memory and processor air ducts. For instructions, see “Installing the
Processor and Memory Air Ducts” on page 21.
15. Re-install the chassis cover. For instructions, see “Installing the Chassis Cover” on
page 17.
16. Plug all peripheral devices and the AC power cable into the server.
17. Power up the server.
Replacing the Control Panel
The steps for replacing the front control panel and the Intel
®
Local Control Panel are
nearly identical. Use the following steps for both varieties of the control panel. Where
necessary, differences between the two control panels are noted.
Your server must be operated with a control panel installed.
Caution: The control panel is NOT hot swappable. Before removing or replacing the control panel,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover” on
page 16.
4. Remove the front bezel if it is installed. For instructions, see “Removing and
Installing the Front Bezel” on page 18.
5. Press the latch at the back of the control panel.
6. Slide the control panel out through the front of the chassis far enough so that you
can reach the front panel and USB cable connectors at the rear of the control panel.
7. Disconnect cables.
8. Install the control panel module into the chassis.
9. Reconnect cables.
10. (Optional) Install the front bezel. For instructions, see “Removing and Installing the
Front Bezel” on page 18.
11. Install the chassis cover. For instructions, see “Installing the Chassis Cover” on
page 17.
12. Plug all peripheral devices and the AC power cable into the server.
13. Power up the server.