JVC 0402-Ki-NV-JMT CRT Television User Manual


 
38
Connecting AV COMPU
LINK Supported Devices
AV COMPU LINK remote control system is a
system in which related devices are
automatically controlled when you operate
one device.
If you apply this system to the TV, you can
have the TV automatically perform the
required operations by operating one
external device. You don't have to use the
TV's remoto control to turn on the TV or
change the VIDEO modes.
Examples of the AV
COMPU LINK remote
control system operations
Simply by pressing the PLAY button on a
VCR or a DVD player, you can view images
from the device.
Simply by inserting a pre-recorded tape (a
tape with the record safety tab removed) to a
VCR, you can view the tape.
Simply by operating the AV Control Rece-
iver, you can have the TV turned on/off (in
standby mode) or the VIDEO mode changed
correctly.
The performance of the AC COMPU
LINK remote control system varies
depending on the connected device.
See the devices instruction manual.
When you select "TV SOUND" as the
input source with the AV Control
Receiver, there are cases where the TV's
MUTING function automatically operates
and the sound from the TV's speakers is
muted.
In such cases, press the VOLUME-/+
buttons or the MUTING button on the
TV's remote control to cancel the MUT-
ING function. You can regain the sound
from the TV's speakers.
Conditions to use the AV
COMPU LINK remote
control system
A device equipped with an AV COMPU
LINK terminal is required.
You must connect the TV and the device
with an AV COMPU LINK cable.
AV COMPU LINK cable is not supplied
with this TV. If an AV COMPU LINK cable
is unavailable, connect them with a cable
with dia. 3.5 mm (mono) male plugs at
both ends.
You must connect the device to an
appropriate VIDEO terminal and set it up
correctly. Otherwise the AV COMPU LINK
remote control system will not function
correctly. For details, see Setting up the
AV COMPU LINK remote control
system.
The TV must be in standby mode (the
POWER lamp lighting red). If the TVs
Main power is off (the POWER lamp off),
the AV COMPU LINK remote control
system does not function.
Setting up the AV COMPU
LINK remote control system
CAUTION:
With some devices, the setup method
differs from the ones explained here.
Be sure to read the devices instruction
manual thoroughly before setting it up.
1 Connect the device to the TV’s
VIDEO-1 or VIDEO-2 terminal.
If you want to connect a DVD
player to the TV with a compo-
nent video cable :
Connect the DVD player to the TVs VIDEO-3
terminal.
For detailed connecting instructions, see
"Connecting the external devices" on
page 36.
Additional preparation
LCT1218-001A-H_p22-44 4/9/02, 6:53 PM38
Black