Filter
Top Products
18
VOLUME:
@
+01
q
PI CTURE ADJUST
r
CONTRAST
BRI GHT
CHROMA
PHASE
:0
:0
:0
:0
:
ENTER
NOTE
NOTE
NOTE
On-screen menu remote operation
Remote keys and front controls with the same designation share the
common functions. For detailed operation, see instructions about each
menu function in this manual.
Picture adjustments
Each adjustable range depends on the setting of the front CONTRAST/
BRIGHT/CHROMA or PHASE control. If an adjustment is made via remote
control with the front control set approximately to the maximum or minimum,
the level may indicate a certain change on screen but may not actually
increase or decrease.
1. Press the PICTURE key to display PICTURE ADJUST.
2. Press the ▲ or ▼ key to select an item.
3. Press the or key to change the level:
: Moves the cursor to left (to decrease the level).
: Moves the cursor to right (to increase the level).
4. Press the ▲ or ▼ key to another item and repeat step 3.
5. Press the PICTURE key to complete.
● To standardize all settings on PICTURE ADJUST:
After step 1, press the RESET key.
REMOTE CONTROLS
The optional wireless remote control unit (RM-C550W) operates the following:
● On-screen menu functions (MENU, SET-UP MENU, etc.)
● Picture adjustments (CONTRAST, BRIGHT, CHROMA, PHASE)
● Sound adjustments (VOLUME, MUTE)
Sound adjustments
A variable range depends on the setting of the front VOLUME control.
If audio level is remote-controlled with front VOLUME control set approxi-
mately to the maximum or minimum, the level may indicate a certain change
on screen but may not actually increase or decrease.
● Press the VOLUME – or + key to decrease or increase the level (within ±20).
● Press the MUTE key to mute the sound. MUTE appears on screen for
approx. 3 seconds. Press again to release.
● If the power is turned off with sound-
muting activated, the function is kept
in memory.
● To release sound-muting, turn the
front VOLUME control or press the
remote VOLUME – or + key .
● When monitoring the picture of analog
RGB signals, component signal or
black-and-white signal, CHROMA and
PHASE do not appear and cannot be
adjusted.
● When a video signal of the PAL sys-
tem is input to the monitor, PHASE
does not appear and cannot be ad-
justed.
● Each time the PICTURE key is pressed,
the previous display is restored.