Filter
Top Products
E-66
OTHERS
– Warning display –
When an anomaly occurs, this unit automatically identifies the cause and displays an error-
coded warning message on the monitor.
If the unit is in a state needing rectification, or if an operation error has occurred, an alarm
display will be shown on the monitor.
32K CH–1/2
SP
000
min
W
ARNING 7001
DRUM MOTOR FAI LURE
10/10/02 STANDBY
-
OFF
12:00:00 TCR 02:00:00:00
Warning display
32K CH–1/2
SP
000
min
HEAD CLEANING REQUI RED!
10/10/02 STANDBY
-
OFF
12:00:00 TCR 02:00:00:00
Alarm display
Ⅵ Alarm display (Displayed regardless of the DISPLAY mode)
Display Status Action
LOW VOLTAGE
HEAD CLEANING
REQUIRED!
OVER HEATING!
UNPLUG MAIN
POWER, PLUG
BACK IN AFTER A
WHILE
The DC power voltage is low.
The unit will eventually go into the OPERATE
OFF mode if operation is continued.
The video head is dirty. If the head is clogged, it
will be detected and the alarm message will be
displayed during the PLAYBACK mode. When
the STOP mode is engaged or when the cas-
sette is ejected, the display will go off.
When the head clog is cleared, the message
will disappear.
The internal temperature of the unit has ex-
ceeded the regulated value.
This is a system error that occurs when the
power is turned on. The OPERATE indicator on
this unit blinks in green. The unit will not accept
any operation commands.
Please check the power voltage.
Please clean it with the dedi-
cated head-cleaning tape.
(
☞
Page 8)
If the message persists despite
cleaning, it could be due to bad
recording condition, bad tape or
lifespan of the head.
Please disconnect the power
and place the unit in a cool
place. If this message is dis-
played again, the unit may have
been damaged. Please consult
your JVC authorized dealer.
Unplug the power cord from the
power outlet and wait for some
time before plugging it back in.
• For alarm displays resulting from operation errors, please refer to page 22.