Masterpage:Right+
EN 23
Filename [DR-MV1SEK_04Name.fm]
Page 23 April 15, 2004 3:19 pm
INITIAL SETTINGS
The following procedure is required if you receive satellite channels
through a satellite receiver. Approximately 20 seconds before the
VIDEO Plus+ Timer Programming (੬ pg. 45) or Manual Timer
programming (੬ pg. 46) starts, the unit sets its input mode to “L-2”
and automatically switches the satellite receiver’s channels using a
provided Satellite Controller.
Installing Satellite Controller
1 Place a Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
2 Fix securely using the adhesive strip attached on the back of the
Satellite Controller.
3 Be sure to connect the unit’s L-2 IN/DECODER connector to the
satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4 Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Setting Satellite Receiver’s Brand And Channel
After installation, set the satellite receiver’s brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
1 Turn on the satellite receiver’s power.
2 Press SET UP to access the Main Menu screen.
3 Press we to select “INITIAL SET UP”, then press ENTER.
4 Press we to select “SAT/
GUIDE PR”, then press ENTER.
5 Press rt to select “SAT
BRAND”, then press ENTER.
6 Press rt to select the brand
code from the list on page 24,
then press ENTER.
● If the brand code you entered is
invalid, the code field will be reset.
Enter the correct brand code again.
● If the unit is in playback or recording mode, you cannot set the brand
code.
7 Press the appropriate number
keys to enter one of the channel
positions on the satellite receiver,
then press ENTER twice. The unit
enters the Test mode.
● You can select the channel
position between 1 to 999.
Satellite Receiver Control Setting (DVD
Deck Only)
2
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Tran smi tt er
21-pin SCART cable
(provided)
SAT CONTROL L-2 IN/DECODER
Your unit
Satellite Controller
(provided)
Satellite receiver
Back of unit
1
4
7
2
5
8
0
3
6
9
VCR/DVD
rtw e
SAT
ENTER
SET UP
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
CONTINUED ON NEXT PAGE
DR-MV1SEK_00.book Page 23 Thursday, April 15, 2004 3:30 PM
