Filename [DR-MV1SEK_04Name.fm]
Masterpage:Left+
24 EN
Page 24 April 15, 2004 3:19 pm
INITIAL SETTINGS
8 Check the result of the test.
If the satellite receiver’s
channel number has been
changed to the same one as
you set in step 7
Press we to select “YES”, then
press ENTER to finish the Sat
Control Set mode.
If the satellite receiver’s
channel number has not been
changed correctly
Press we to select “NO”, then press ENTER. Then perform the
procedure again from step 5.
NOTES:
● The Satellite Controller may not work with all types of satellite
receiver.
● For some satellite receivers, you need to set its channel input mode
to 2-digit.
● If your satellite receiver has more than two channel modes, be sure to
set to “All Channel Mode”. For details, refer to the instruction manual
of the satellite receiver.
● When selecting the satellite receiver’s channel (੬ step 7), signals
from the remote control may interfere with signals transmitted from
the Satellite Controller. In this case, move the remote control as close
to the unit’s infrared beam receiving window as possible.
BRAND NAME CODE
JVC
AMSTRAD
ASTON
CANAL SATELLITE
CANAL +
D-BOX
ECHOSTAR (VIA DIGITAL)
FINLUX
FORCE
GALAXIS
GRUNDIG
HIRSCHMANN
HUMAX
ITT NOKIA
JERROLD
KATHREIN
LUXOR
MASCOM
MASPRO
NOKIA
PAC E
PANASONIC
PHILIPS
RADIX
RFT
SABA
SAGEM
SALORA
SAMSUNG
SIEMENS
SKY DIGI BOX
SKYMASTER
TECHNISAT
THOMSON
TPS
TRIAX
WISI
73
60, 61, 62, 63, 92
97
81
81
85
82
68
89
88
64, 65, 102
64, 78, 99
88
68
75
70, 71, 96
68
93
70
87, 94
65, 67, 74, 86, 92, 97
74, 92
66, 84, 101
78
69
97
83, 90
68
83
64
92
69, 98
66, 100
97
83
91
64
DR-MV1SEK_00.book Page 24 Thursday, April 15, 2004 3:30 PM