Filter
Top Products
Filename [DR-MV1SU_10Subsidiary.fm]
Masterpage:Left+
82 EN
Page 82 March 4, 2004 4:00 pm
TROUBLESHOOTING
Playback (VCR Deck)
● The VCR deck is not selected.
] Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
● The tape is already fully rewound or fast-forwarded.
] Check the cassette.
● The TV receiver’s channel selector is not set to the video
channel.
] If you are using the RF connection, set the TV receiver to the
video channel.
] If you are using the AV connection, the TV receiver is not set to
the AV mode.
● The unit’s video channel has not been correctly set.
] Perform the video channel set. (੬ pg. 17)
● This is normal.
● The automatic tracking mode is engaged.
] Try manual tracking. (੬ pg. 49)
● The video heads may be dirty.
] Use a dry cleaning cassette ECL-3F, or consult your JVC dealer.
● The automatic tracking mode is engaged.
] Try manual tracking. (੬ pg. 49)
Recording (DVD Deck)
● The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast.
(੬ pg. 21)
● No disc or a disc not being compatible with the unit is loaded.
] Load a recordable disc on the unit. (੬ pg. 8)
● The disc loaded is not formatted.
] Format the disc. (੬ pg. 78)
● A finalized DVD-R disc is loaded.
] Recording cannot be made on finalized discs. Load a recordable
disc on the unit.
● The disc is full or does not have enough space for the program
to be recorded.
] Clear unnecessary programs on the disc or load a blank disc.
(੬ pg. 57)
Recording (VCR Deck)
● The unit is in the Record Pause mode.
Press 4 to resume recording.
● There is no cassette loaded, or the cassette loaded has had its
record safety tab removed.
] Insert a cassette, or using adhesive tape, cover the hole where
the tab was removed.
● “L-1” or “F-1” has been selected as the input mode.
] Set to the desired channel.
● The camcorder has not been properly connected.
] Confirm that the camcorder is properly connected.
● The input mode is not correct.
] Set the input mode to “F-1”.
● The end of the tape was reached during recording.
] The program may not have been recorded in its entirety. Next
time make sure you have enough time on the tape to record the
entire program.
The VCR deck can not be operated.
The tape will not rewind or fast-forward.
The playback picture does not appear while the tape is running.
Noise appears during visual search.
Noise appears during normal playback.
The playback picture is blurred or interrupted while TV
broadcasts are clear or “USE CLEANING CASSETTE” message
appears on the screen.
Breaks are noticeable in Hi-Fi soundtrack.
The desired program cannot be recorded.
Recording cannot be made.
During recording, the tape does not run. The VCR recording lamp
lights up on the front display panel.
Recording cannot be made.
TV broadcasts cannot be recorded.
Camcorder recording is not possible.
The tape is automatically rewound, then the unit is shut off.
DR-MV1SU_10Subsidiary.fm Page 82 Thursday, March 4, 2004 4:01 PM