Filter
Top Products
19
PICTURE SETTING
Item To do Setting value
PICTURE MODE Selects a picture mode you want (see “Selecting the picture mode”
on page 16).
DYNAMIC, NORMAL, USER
CONTRAST Adjusts contrast of the picture. –20 += 00 += +20
BRIGHT Adjusts the brightness of the picture. –20 += 00 += +20
CHROMA Adjusts the color density of the picture (except for RGB and BW
(50 Hz/60 Hz) signals).
–20 += 00 += +20
PHASE Adjusts the color phase. –20 += 00 += +20
SHARPNESS Adjusts the outlines of the picture. –20 += 00 += +20
BACK LIGHT Adjusts the brightness of the display. –20 += 00 += +20
COLOR TEMP. Selects the color temperature. HIGH, MID, LOW, USER
sub menu Displays the adjustment bar which enables you to adjust the items in “PICTURE SETTING”
(except for “CTI/LTI”) while viewing the actual picture.
CTI/LTI Adjusts the clearness of the picture. OFF, 1, 2
reset Restores the default setting for all the items in “PICTURE SETTING.”
NOTE
• You can adjust the items in “PICTURE SETTING” for each picture mode. Select a picture mode you want to adjust fi rst. (The setting values are
stored.)
• “PHASE” does not appear on the menu for the following input signals:
– RGB, PAL, SECAM, BW (50 Hz/60 Hz)
• You can make the detailed settings of the color temperature using the set-up menu (see “COLOR TEMP.” on page 25).
SIZE SETTING
Item To do Setting value
H SIZE Adjusts the horizontal screen size.
Varies depending on other
settings.
H POSITION Adjusts the horizontal screen position.
V SIZE Adjusts the vertical screen size.
V POSITION Adjusts the vertical screen position.
DOT CLOCK Adjusts to eliminate stripes or fl ickering when analog signals
are being input from a computer. Use with “CLOCK PHASE.”
Normally, no adjustment is needed.
–10 += 00 += +10
CLOCK PHASE Adjusts to eliminate stripes or fl ickering when analog signals
are being input from a computer. Use with “DOT CLOCK.”
Normally, no adjustment is needed.
–32 += 00 += +32
ASPECT Selects the aspect ratio (see “Changing the aspect ratio” on
page 15).
REGULAR, FULL, ZOOM,
PANORAMIC, REAL DOT
sub menu Displays the adjustment bar which enables you to adjust H SIZE/POSITION, V SIZE/POSITION,
DOT CLOCK, and CLOCK PHASE while viewing the actual picture.
reset Restores the default setting for all the items in “SIZE SETTING.”
NOTE
• During the size and position adjustments, the picture may be distorted but this is not a malfunction.
• Size and position adjustments are related so that if one is set to a higher setting value, the other’s setting value will be reduced.
05-39_GM-H40L1G-f.indd 1905-39_GM-H40L1G-f.indd 19 05.10.6 1:13:34 PM05.10.6 1:13:34 PM