Filter
Top Products
Masterpage:Right-NoTitle0
EN
11
Filename [HDS1EU_1.fm]
Page 11 June 21, 2001 12:29 pm
How To Use
The remote control can operate most of your video recorder’s functions, as well as basic functions of TV sets and satellite receivers
of JVC and other brands. (
੬
pg. 49,
50)
● Point the remote control toward the receiving window.
● The maximum operating distance of the remote control is about 8 m.
NOTES:
● When inserting the batteries, be sure to insert in the correct directions as indicated under the battery cover.
● If the remote control doesn’t work properly, remove its batteries, wait a short time, replace the batteries and then try again.
Remote Control LCD
The remote control can operate not only the video recorder but also some of your TV and satellite receiver’s functions. The LCD
indicates which of these (VIDEO, TV or CABLE/SAT) the remote control can currently operate. When you first purchase the remote
control, or after you have just replaced the batteries, VIDEO A (A code) is selected.
NOTES:
Even if “TV” is displayed on the LCD, the following operations can be performed without switching the mode.
● Basic operations for the recorder
After an operation is completed, “TV” reappears on the LCD.
● Express timer programming and S
HOW
V
IEW
timer programming operations
To perform a TV operation again, switch to TV mode first.
● Accessing main menu
To perform a TV operation again, switch to TV mode first.
A
To operate your video recorder, first press the
HDD
or
S-VHS
. To
switch the remote control’s A/B/C/D code, refer to page 48.
B
To operate your TV, first press
TV/CABLE/SAT
until “TV” appears
on the LCD. (
੬
pg. 49)
C
To operate your satellite receiver, first press
TV/CABLE/SAT
until
“CABLE SAT” appears on the LCD. (
੬
pg. 50)
HDS1EU_.book Page 11 Thursday, June 21, 2001 12:30 PM