Filter
Top Products
Filename [HDS1EU_5.fm]
Masterpage:Left
92
EN
Page 92 June 21, 2001 12:30 pm
TROUBLESHOOTING (cont.)
TIMER RECORDING
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Timer recording won’t work.
●
The clock and/or the timer have
been set incorrectly.
Re-perform the clock and/or timer
settings.
●
The timer is not engaged. Press
#
and confirm that “
#
” is
displayed on the front display panel.
2. Timer programming is not
possible.
●
Timer recording is in progress. Timer programming can’t be
performed while a timer recording is
in progress. Wait until it finishes.
3. “
#
” and “
[
” on the front display
panel won’t stop blinking.
●
The timer is engaged but there’s no
cassette loaded.
Load a cassette with the record safety
tab intact, or cover the hole using
adhesive tape.
●
The loaded cassette has had its
record safety tab removed.
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the record safety tab
intact.
●
The end of the tape was reached
during timer recording.
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire
programme.
4. “
#
” blinks for 10 seconds and the
Timer mode is disengaged.
●
#
has been pressed when there are
no programs in memory.
Check the programmed data and re-
program as necessary, then press
#
again.
5. The S
HOW
V
IEW
system does not
timer-record properly.
●
The recorder’s channel positions
have been set incorrectly.
Refer to “Guide Program Number
Set” (
੬
pg. 79) and re-perform the
procedure.
HDS1EU_.book Page 92 Thursday, June 21, 2001 12:30 PM