Filter
Top Products
Filename [HDS1EU_2.fm]
Masterpage:Left
38
EN
Page 38 June 21, 2001 12:25 pm
RECORDING/PLAYBACK ON VHS DECK (cont.)
Elapsed Recording Time Indication
1
Set the counter display.
Press – –:– – until a counter reading appears on the front
display panel.
2
Reset the counter.
Press
0000
before starting recording or playback.
● The counter is reset to “0:00:00” and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
Tape Remaining Time
Press – –:– – until the time remaining on the tape
appears.
● The front display panel shows the tape remaining time with
“
y
” displayed.
● By pressing the – –:– – button, you can change the display to
show the counter reading, channel position*, clock time or
tape remaining time.
* Channel position is not displayed during playback.
NOTE:
Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
“– –:– –” may sometimes appear, or the display may blink on
occasion.
Retake
You can cut out unnecessary parts of a TV programme while you
are recording it.
1
Engage the Record-Pause mode.
Press
9
during recording.
2
Locate the start point.
Hold down
3
or
5
and release it when you reach
the point where you want to resume recording.
● Your recorder returns to the Record-Pause mode.
3
Resume recording.
Press
4
when you wish to resume recording.
NOTES:
● Retake function does not work during Direct Rec (
੬
pg. 21,
78).
● Noise may appear when Retake function is used at the part
that is recorded in EP mode.
End of programme Beginning of programme
Recorded part
Go back to end of programme to cut out
unnecessary part
Programme Programme
Unnecessary
part
Unnecessary
part
HDS1EU_.book Page 38 Thursday, June 21, 2001 12:30 PM