Filter
Top Products
Filename [DVS3EK_1a-EN.fm]
Masterpage:Left
30
Page 30 November 5, 2001 1:37 pm
PLAYBACK/RECORDING ON DV DECK
Basic Playback
(DV deck)
A
Load a cassette.
Make sure the window side is up, the rear label side is
facing you and the arrow on the front of the cassette is
pointed toward the recorder.
● Do not apply too much pressure when inserting.
● The recorder’s power comes on automatically.
● If the erase protection switch is set to “SAVE”, playback begins
automatically. It takes about 15 seconds until the playback
picture appears.
● Make sure the VCR indicator appears on the front display
panel. If not, press
TV/VCR
on the remote control to turn on
the VCR indicator.
B
Select the DV deck.
Press
DV
.
● The DV button lights on the recorder.
C
Find the programme start point.
If the tape is advanced past the start point, press
3
or
turn the
JOG
dial to the left. To go forward, press
5
or
turn the
JOG
dial to the right.
D
Start playback.
Press
4
.
● The DV playback indicator lights on the recorder.
E
Stop playback.
Press
8
. Then press to remove the cassette.
● The DV playback indicator turns off.
NOTE:
When you record a tape on the DV deck with the recording
speed set to “LP”, it is recommended to play back that tape back
on this DV deck. Digital video recorder from other
manufacturers may not be able to play back the tape properly.
Turn on the TV and select the AV mode.
1
32
123
456
789
1
2
1
2
3
0
3
4
4
Usable cassettes
Only cassettes marked can be used with the DV
deck.
DVS3EK_1-EN.book Page 30 Monday, November 5, 2001 1:43 PM