Filter
Top Products
Filename [DVS3EK_3-EN.fm]
Masterpage:Left
48
Page 48 November 5, 2001 1:37 pm
EDITING (cont.)
Edit From A
Camcorder
You can use a camcorder as the source player and your
recorder as the recording deck.
You can perform digital dubbing if you connect a device
such as a camcorder which has a DV IN/OUT connector.
Because the signals are digital, there is no loss of video or
audio quality as a result of editing.
A
Make connections.
A
If the camcorder has no S-VIDEO output connector...
... connect the camcorder’s AUDIO OUT and VIDEO
OUT connectors to the recorder’s front panel AUDIO
and VIDEO input connectors.
B
If the camcorder has an S-VIDEO output connector ...
... connect the camcorder’s AUDIO OUT and
S-VIDEO OUT connectors to the recorder’s front panel
AUDIO and S-VIDEO input connectors.
C
If the camcorder has a DV IN/OUT connector...
... connect the camcorder’s DV IN/OUT connector to
the recorder’s DV IN/OUT connector.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your recorder.
● When a Master Edit Control-equipped JVC camcorder is used,
the camcorder is capable of controlling the recorder. Refer to
the camcorder’s instruction manual for operating procedure.
B
Select the recording deck.
Press
VHS
or
DV
.
C
Set the recorder’s input mode.
Press
AUX
(
number key
“
0
”) and/or
PR
to select “F-1”.
● When using the VHS deck as the recording deck, set “VHS F-1
INPUT” to “VIDEO” for the AUDIO/VIDEO input connectors,
or “S-VIDEO” for the AUDIO/S-VIDEO input connectors,
depending on the connectors being used (
੬
pg. 53).
D
Set the edit mode. (VHS deck only)
See “PICTURE CONTROL” on page 68.
E
Start the camcorder.
Engage the Play mode of the camcorder.
F
Start the recorder.
Engage the Record mode of the recorder.
123
456
789
1
2
1
2
3
0
3
4
4
DVS3EK_1-EN.book Page 48 Monday, November 5, 2001 1:43 PM