Filter
Top Products
Filename [DVS3EK_3-EN.fm]
Masterpage:Left
46
Page 46 November 5, 2001 1:37 pm
EDITING (cont.)
Normal Dubbing
(from DV to VHS)
NOTES:
●
If you set the dubbing direction incorrectly, you could erase an
important recording that you wanted to copy. It is
recommended to conduct a test with unimportant cassettes
first.
●
There may be a discrepancy of several seconds between
where you intend editing to start, and where it actually starts.
●
The superimposed indication during the operation or dubbing
is not recorded.
●
To cancel the dubbing mode, press
PR +/–
so that the dubbing
direction indicator (DV ) goes off.
●
When dubbing a Mini DV tape that was produced by audio
dubbing, you need to set “12BIT MODE” to the appropriate
mode before playing back the tape. (
੬
pg. 71)
You can dub selected scenes on a tape, starting and stopping
wherever you wish.
A
Load cassettes.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab intact, or cover the hole using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to “SAVE”.
B
Select the dubbing direction.
Press .
● The dubbing direction indicator (DV ) lights.
C
Set the tape speed.
Press
VHS
, then press
SP/LP (
p
)
.
● “DV ]
VHS” appears on the TV screen if “O.S.D.” is set to
“ON”. (
੬
pg. 67)
D
Locate the start point on the DV deck.
A
Press
DV
.
B
Press
4
to start playback.
C
Press
9
to pause playback a little before the start
point.
E
Prepare the VHS deck for dubbing.
A
Press
VHS
.
B
Press and hold
9
and press
7
so that the VHS deck
enters the Record Pause mode.
● DV playback indicator and VHS recording indicator light.
F
Start dubbing.
Press
START
.
G
Pause dubbing.
Press
START
.
● The VHS deck enters the Recording Pause mode, then the DV
deck enters the Dubbing Pause mode.
H
End dubbing.
Press
8
to stop recording on the VHS deck. Then press
DV
and press
8
to stop playback on the DV deck.
123
456
789
1
2
1
2
3
0
3
4
4
1
32
DVS3EK_1-EN.book Page 46 Monday, November 5, 2001 1:43 PM