Filter
Top Products
Masterpage:Right-No-Heading
EN 73
Filename [XVC23U_09Editing.fm]
Page 73 13 February 2004 3:50 pm
Connecting To A Dolby Digital Decoder
or An Amplifier With A Built-in DTS
(DVD deck only)
These instructions enable you to connect your unit to dolby digital decoder or amplifier with a built-in DTS.
Make connections.
Connect the coaxial cable between the unit and the
Dolby Digital decoder or amplifier with a built-in DTS.
NOTES:
● For Dolby digital sound, set “DIGITAL AUDIO OUTPUT” to
“DOLBY DIGITAL/PCM”. (
੬ pg. 78)
● For DTS sound, set “DIGITAL AUDIO OUTPUT” to “STREAM/
PCM”. (
੬ pg. 78)
CAUTIONS:
● This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
Back of unit
Coaxial cable
(not supplied)
Dolby Digital decoder or
amplifier with a built-in DTS
DIGITAL AUDIO OUT
To DIGITAL AUDIO
input
XVC23U_09Editing.fm Page 73 Friday, February 13, 2004 3:50 PM