JVC HR-XVC27UM DVD VCR Combo User Manual


 
Masterpage:Right-No-Heading
EN 33
Filename [XVC27UM_07S-VHS.fm]
Page 33 14 June 2004 4:21 pm
Elapsed Recording Time Indication
1 Set the counter display.
Press DISPLAY until a counter reading appears on the
front display panel.
2 Reset the counter.
Press C.RESET before starting recording or playback.
The counter is reset to “0:00:00” and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
Tape Remaining Time
Press DISPLAY until the time remaining on the tape
appears.
The front display panel shows the tape remaining time with “:”
blinking.
By pressing the DISPLAY button, you can change display to
show the channel position*, clock time, counter reading or
tape remaining time.
* Channel position is not displayed during playback.
NOTES:
When you press ON SCREEN, the on-screen display appears
on the TV screen for 5 seconds, then the displays other than
the counter disappears. To clear the counter display, press ON
SCREEN.
Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
“– –:– –” may sometimes appear with “:” blinking, or the
display may blink on occasion.
Second Audio Recording
This unit’s built-in MTS decoder enables reception of
Multichannel TV Sound broadcast. To record a SAP program
received, set “2ND AUDIO RECORD” to “ON”. (
pg. 74)
NOTE:
When the channel is changed on the unit;
The “STEREO” indicator appears on the screen for about
5 seconds if the program is a stereo broadcast.
The “SAP” indicator appears on the screen for about 5 seconds
if the program is a SAP broadcast.
Both indicators appear when a stereo program is accompanied
by SAP sound.
XVC27UM_07S-VHS.fm Page 33 Monday, June 14, 2004 4:21 PM