JVC HR-XVC27UM DVD VCR Combo User Manual


 
Filename [XVC27UM_09Editing.fm]
Masterpage:Left
70 EN
Page 70 16 June 2004 10:36 am
REMOTE
Remote Control
Functions
Remote A/B/C/D Code Switching
The Remote is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
On the Remote
Keep pressing VCR down during steps A B.
A
Change the remote control code.
Press the number key “1” for A, “2” for B, “3” for C or
“4” for D.
B
Set the remote control code.
Press ENTER to set the code.
NOTE:
Once the batteries are removed, the remote control code is back
to A.
On the unit
C
Turn off the unit.
Press POWER (1).
D
Display the code.
Press PLAY (4) on the unit for over 5 seconds while the
unit is turned off. The code currently set appears on the
front display panel.
If the code displayed on the front display panel is different
from the code set on the Remote, go to step E.
E
Change the unit’s code.
Press STOP (8) on the Remote. The code currently set on
the Remote will be applied to the unit.
NOTE:
Even if you unplug the end of the mains power cord from the
mains, the code currently set remains.
Before performing the following steps:
Slide the TV/VCR/DVD switch to the right.
XVC27UM_09Editing.fm Page 70 Wednesday, June 16, 2004 10:36 AM