Filter
Top Products
63
Save the box and packaging from your replacement lamp.
You can use this packaging to return your used projection
lamp for recycling. Please do not throw the used lamp out
with normal trash. A pre-paid label is provided for this
purpose. To package your used lamp for shipment, follow
the simple steps below.
1) Collect the box and packaging from the replacement
lamp. Make sure the used projection lamp has fully cooled
before packaging.
2) Carefully wrap the used lamp in the bag which contained
the new projection lamp. Close and secure the bag.
3) Place the bag with the lamp inside the box with the
original packaging material. Close and seal the box with
packing tape.
4) Remove the old shipping label. Place the new pre-paid
shipping label on the outside of the box. You may give the
box to any mail carrier or drop it off at your local post office
for shipping.
Warning Messages
If the lamp replacement was successful, the television will operate normally. If there was a problem with the instal-
lation, one of several messages may display on the front panel LED lights.
Lamp installed on a slant or not fully inside the television.
If the lamp unit has been installed into the unit slanted (not flat) or is not fully inserted into the lamp housing
inside the television, when the television is turned on the ON TIMER and POWER light will be flash. The 10 LEDs
will light, then turn off one each five seconds. When all LEDs are off, the television still will not display a picture.
To correct: Reinstall the new lamp unit. Repeat the lamp installation steps, taking care to observe all warnings.
Make sure when the lamp unit is reinstalled, it is inserted into the unit so it sits FLAT inside the unit.
If the ON TIMER light or POWER light is flashing you need to reset the television. Reset the television by unplug-
ging the power cord from the AC outlet and then plugging the cord back into the outlet.
Filter not properly reinstalled.
If the filter unit has not been correctly reinstalled or if the filter has been damaged, the television will not turn on.
When the Power button is pressed the 10 LEDs will turn on, then one will turn off every five seconds. When three
have turned off the television will then enter a cool-down mode and the power will turn off.
To correct: Check to see that the filter has been installed properly. Repeat steps 1 to 5 and 8 to 10. You do not
need to remove and reinstall the lamp. If the television still does not turn on, the filter may have been damaged.
Call a service technician for repair.
If the television does not work properly, or displays a message not listed here, call a technician for service.
Recycling Information
Appendix B
The lamp assembly in this product contains mercury. Disposal of the lamp
assembly may be regulated due to environmental considerations. For
information on replacement, disposal or recycling procedures, please
contact JVC Customer Relations at 1-800-252-5722.